HD45 - Hotrod Flames - Small

#45 - Hotrod Flames - Small

By popular request, we are adding this pack of HD stencils that features just the smaller sizes of flames from the HD22 Hotrod Flames pack.

This HD45 pack includes 4x each of the smallest 3 sizes of flames (HD22 has 2x each size, but includes bigger sizes) for a total of 12x flame strips and 12x negative flame stips, which can be cut to length as desired.

You are able to use both the positive, and negative parts of the stencils.

Obviously you can use any colours of your choice, not just those shown.

As standard, our HD stencils come on an (approximately) A4  sized sheet designed to fold down the middle, or sometimes 2x A5 sheets end to end, either way, you get the same amount of stencils.

(A4 = 297 x 210mm or 11.7 x 8.3 inches)

Our HD stencil System utilises a thin flexible self adhesive film material specially designed for this purpose, featuring the following properties.

• Its is self adhesive, but with low tac, to help stop it peeling paint from your models
• Solvent proof, should you with to use solvent based paints.
• Has a moderate amount of stretch to help it go in and around complicated detail.
• transparent, so you can see exactly where you are putting it, but slightly grey in colour so you can still see it.

Our HD stencils are best used with an  airbrush, but some spray cans may be used if care is taken, and they are a thin spray like many primers (gloss sprays will not work well)
.
Some designs can also work well when used with a sponge to apply the paint.
.
Brush painting is not ideal, but could be used for some designs if great care was taken.